Cs adsorption by Mn‒Fe-based Prussian blue analogs formed in agarose gel

The Fukushima nuclear accident triggered a massive release of radioactive cesium (Cs) isotopes into the environment and generated a large amount of contaminated water. Because Cs isotopes pose serious threats to the environment (particularly the aquatic environment), selective, efficient, and inexpensive sorbents for Cs+ions in solutions are highly desired. Currently, the most promising Cs sorbents are Prussian blue (PB) and their analogs (PBAs). For instance, PB has been approved as a drug used in clinics for the treatment of radioactive Cs exposure.

Atlas of Science. Cs adsorption by Mn‒Fe-based Prussian blue analogs formed in agarose gel

Fig. 1. (A) A snapshot of the Mn‒Fe PBA precipitates spontaneously formed in agarose gel and (B) a SEM image of the precipitates, obtained at magnifications of 5000. (C) Depicting the Cs adsorption at the Mn‒Fe PBAs in agarose gel.

PB and PBAs exhibit a wide variety of compositions, crystal structures, and Cs adsorption abilities, and these properties strongly depend on the reaction conditions and preparation methods. In a recent study published inthe Journal of Analytical Atomic Spectrometry(2019, 34, 979–985), we reported that the precipitation bands of Mn‒Fe-based PBAs (Mn‒Fe PBAs) in agarose gels trap Cs+比铅离子更有效。在这圣udy, such strong adsorption of Cs+ions by the Mn‒Fe PBAs was investigated by extended X-ray absorption fine structure (EXAFS) spectroscopy coupled with scanning electron microscopy (SEM). For these measurements, gel samples were prepared by contacting a gel containing 0.05 M [Fe(CN)6]3−and 2.3 mass% agarose with a 0.50 M MnSO4solution, into which a 0.10 M CsCl solution was introduced. The Mn‒Fe PBA precipitates spontaneously form relatively broad, periodic banding structures in agarose gel (Fig. 1A). The SEM revealed that the Mn‒Fe PBA precipitates consist of aggregates of cubic crystallites that bear considerable amounts of defects (Fig. 1B).

Atlas of Sciene. Cs adsorption by Mn‒Fe-based Prussian blue analogs formed in agarose gel

Fig. 2. Depicting (A) the type-A and (B) type-B cluster models used to analyze (C) the Cs L3-edge EXAFS data.

Figure 2A and B display cluster models used to analyze the Cs L3-edge EXAFS profile. In the type A cluster, a Cs+ion is situated at the body-center of the cube (cubic center) constructed by the Mn‒N‒C‒Fe moieties, which are partially replaced by O atoms (conceivably H2O molecules). In the type B cluster, a Cs+ion is localized at the center of a cube face, being surrounded by the vacant sites. The differences between these models are evident in the Fourier transform (FT) of the EXAFS oscillation (k3χ(k); Fig. 2C). The FT spectrum based on the type A shows only a broad single peak, making it impossible to assign the characteristic two peaks of the experimental FT spectrum (Exp). In contrast, the FT spectrum based on the type B reproduces the two experimental peaks fairly well, attributing the high and low peaks to the first-nearest O and the second-nearest N atoms, respectively, strongly suggesting that the Mn‒Fe PBA crystallites mainly adsorb Cs+ions at large defect sites close to the cube faces. In accordance with this finding, the Mn K-edge XANES results show that many cubic centers in the Mn‒Fe PBAs are mainly filled with H2O molecules or K+ions prior to Cs adsorption, and these molecules/ions are mostly displaced during Cs adsorption. The suggested Cs adsorption mechanism (Fig. 1C) provides valuable first insight toward fully understanding Cs adsorption by Mn‒Fe PBAs.

Hisashi Hayashi
Department of Chemical and Biological Sciences, Faculty of Science, Japan Women’s University, Japan


An XAFS study of Cs adsorption by the precipitation bands of Mn-Fe-based Prussian blue analogues spontaneously formed in agarose gel
Hisashi Hayashi, Saya Aoki, Mao Takaishi, Yui Sato, Hitoshi Abe
Phys Chem Chem Phys. 2019 Oct 28

Facebook twitter linkedin mail Facebook twitter linkedin mail

Leave a Reply